HOW TO USE
1. In your Android or iOS
device, ensure Bluetooth is on.
2. Turn the power switch of
the remote to the ON position, the LED will flash blue.
3. Go to settings for Bluetooth,
select “YUNTENG” from the devices list. Confirm the pairing. The remote LED will
flash rapidly, then stay off after pairing.
4. In the paired devices
list, “YUNTENG” device will read “Connected” and you are ready to go!
5. iOS devices do not
have zoom function, use the remote to take pictures only.
6. For some Android devices,
volume keys can be set as zoom keys in the camera app. DISABLE this function.
It may interfere with shutter release function
7. To use MECHA to
trigger the remote, AF 0 sec must be used. Use any short E delay to trigger the
camera, eg E:0.1 sec. Use
A: value for
adjusting the delay between shots.
If the device fails to connect, make sure that the remote control has enough
power. Check if there are other Bluetooth devices in the connected list, disconnect
them, then turn off and turn on the remote to start pairing again. One remote can be paired to one device only. Unpair the old device to pair new device.
After 5 minutes of inactivity, the remote will enter sleep mode. It can
be waked up by pressing any of its buttons. Turn off the timer when not
in use, to avoid draining the battery by accidental touching of the buttons.