since 2004

# Tutorials

1

Close

Simple Rotations – Single Axis MECHA

In this video, we are going to show you how to perform simple rotations of 45, 90 and 180 degrees, using MECHA Single Axis.
First, power on MECHA and wait until it is idle.
We also recommend that you do not change the default values ​​for "Arrow buttons intervals" on the config page.

Let's get started!

● For 45° rotations, use the left arrow and 1, or right arrow and 1.
Press the left arrow button, then quickly press 1.
Press the right arrow button, then quickly press 1, for the opposite direction.
Let's repeat this step a few times.
Left, 1, right, 1.
On the config page, the "Arrow buttons Interval 1" should be 45 degrees to be able to perform rotations of 45 degrees using the arrow buttons and 1 button.
The rotational speed correspunding to Interval 1, in revolutions per minute, can be set on the config page as well.

● Simillarly, for 90° rotations, use the left arrow and 2, or right arrow and 2.
Press the left arrow button, then quickly press 2.
Press the right arrow button, then quickly press 2, for the opposite direction.
Left, 2, right, 2.
On the config page, the "Arrow buttons Interval 2" should be 90 degrees to be able to perform rotations of 90 degrees using the arrow buttons and 2 button.
There is also a rotational speed corresponding to Interval 2 on the config page.

● For 180° rotations, use the left arrow and 3, or right arrow and 3.
Press the left arrow button, then quickly press 3.
Press the right arrow button, then quickly press 3, for the opposite direction.
Now MECHA is going back to the initial position.
And again, left, 3, right, 3.
On the config page, you can set the desired rotational speed corresponding to Interval 3, and the "Arrow buttons Interval 3" should be 180 degrees to be able to perform rotations of 180 degrees using the arrow buttons and 3 button.

MECHA User's Guide
https://www.nodalninja.com/Manuals/mecha.pdf

MECHA E1 / C1 R Bundles
https://www.fanotec.com/mecha-e1c1-r-bundles/407