MECHA IR Remote Commander and Receiver v.1.2.2 © 2021-2022 FANOTEC 12 o If you are using a C1 Controller, enter the code 3231. by pressing the following buttons on the C1 Controller, one by one: 3231 . Make sure you have entered it correctly (MECHA shows the entered codes on its LEDs), then use the 4 button to confirm. This deactivates the functions of the Commander buttons, and - an important detail - it automatically enables the Use Nodal Ninja IR Remote option. With firmware versions older than 02372, you need to enable this option manually, either on the /config page (after connecting to MECHA's Wi-Fi network) or using the code: 3232 (this code allows you to switch between the enabled and disabled state). o If you are using a C2 Controller, to deactivate the functions of the Commander buttons, access the Config Menu and navigate to the IR REMOTE TEST option, then press the S button. This also enables the USE NN IR option. With firmware versions older than 12372, you need to enable this option manually, in the Config Menu, before starting the test. • After deactivating the functions of the Commander buttons, MECHA no longer executes remote control commands. Instead, when you press a Commander button, MECHA beeps and shows the code of the pressed button (after the button is released): o on its LEDs, when using a C1 Controller; o or on the OLED display, when using a C2 Controller.