Adapt Advanced Rotator top to accept 3/8 inch male thread
Results 1 to 4 of 4

Thread: Adapt Advanced Rotator top to accept 3/8 inch male thread

  1. Adapt Advanced Rotator top to accept 3/8 inch male thread


    I am consider buying the advanced rotater but I am not using the nodal ninji arms. I already have a sizeable investment in Acratech leveling plates, ball head, nodal rail and right angle arm. I would like to place the advanced rotater on top the leveling plate and below the ball head. The leveling plate has a 3/8 male thread on top which would then screw into the bottom of advanced rotater which had a 3/8 thread. Then I would like to screw my Acratech ball head on to the top of the advanced rotater. The issue is the the thread on the rotater is a M6 thread which is close to a 1/4 inch thread.

    One thought I had was to drill our the M6 thread on the top of the rotater and retap it with a 3/8 thread. There are two problems that I see with this. 1) the M6 thread is only 1/2 deep and after drilling the tap would be placed in hole and because the tap is tapered, I wouldn't be able to get a good thread deep enough. 2) Drilling and tapping would probably put shavings down inside the rotater and damage the bearings.

    I was wondering if the head could be partially disassembled to drill and tap the hole and put back together again?

    Any thoughts or solutions would be greatly appreciated.


  2. #2
    Users Country Flag
    Join Date: Aug 2008
    Location: Netherlands
    Posts: 1,741

    Hi Rick and welcome to the forum,

    You can easily solve the problem by using the M6 to 3/8" Adapter. Be sure to set the concave side of the ring to the rotator. That way it will keep the screw in it's place.

    Then you can go on with 3/8" thread on top of the RD16II. Be sure it will keep the weight of your ball head. Normally we do not like to use a ball head on top. Be aware, that it may cause problems with outstanding parts and you have to mask a lot. But just test it.

    Feel free to ask,
    Last edited by hindenhaag; 01-20-2014 at 12:08 PM.
  3. Thanks


    This would be great. Thanks for your help.

  4. #4
    Users Country Flag
    Join Date: Apr 2008
    Location: Hong Kong
    Posts: 2,583

    I can't imagine the benefits of putting a ball head on RD16. What is the point? You have a leveling base at the bottom already. The ball head will only cause misalignment and exert more torque on the leveling base. The overall torque may be 2-3 times of normal configuration that the leveling base is intended to be used.


    We listen. We try harder.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts