im using a R10 for my 5DII with EF 8-15, 7,5° tilted up. In this NN-document (http://www.nodalninja.com/Manuals/QR...non-8-15mm.pdf) there is referenced a rail-stop-plate marked with "103" on it suitable for R10 7.5° with EF 8-15.
So i ordered this but what i received instead is what i attached below. A Plate without any markings but with some tiny bricks, marked by their widths. No manual included :-(
Did i get the wrong part? Anybody knows what this is good for or has a manual how to configure it?