I lost the camera mounting. I need to buy other, but the store is not easy for me

[astromario]

Hi! I bought last year a NN3 MKII Starter Package. Unfortunately my camera was stolen. My camera had the camera mounting and the screw of my NN3. So I lost this part of my NN3.

I need to buy this part in the store, but I am confused, because I don't understand which accessory is correct.

I have this options:

1. NN3 MKII Camera Mounting Knob and Square Washer
   http://store.nodalninja.com/products...re-Washer.html
2. Camera Mounting Plate CP2
   http://store.nodalninja.com/products...ting-Plate-CP2
3. Rail Plate 3/8 inch
   http://store.nodalninja.com/products...%7B47%7D8-inch

What is the correct accessory for my NN3? 1, 2 or 3? Or maybe other... Thank you!

[hindenhaag]

HI,

The square washer is replaced by CP-2. So you need to buy:

http://store.nodalninja.com/products...ting-Knob.html
http://store.nodalninja.com/products...ting-Plate-CP2

3. serves to apply third party camera/QR plates to NN3/NN4/NN5

Normally the Mounting knob stays on the upper rail of NN3 MKII when you take off the camera. It is saved by rubber rings in older versions or with the black plastic washers that came with the set. Insert the knob to the upper rail and then add the washer to the knob. Will keep it on upper rail once you took off the camera.

Think this helps, always a rare feeling if something was stolen.

Regards,
Heinz

[astromario]

Thank you! I will buy this accessories. Bye