Need help please!

Welcome to Nodal Ninja Forum

+ Reply to Thread
Results 1 to 5 of 5

Thread: Need help please!

Share/Bookmark
  1. Need help please!

    #1

    Can anyone help by telling the settings for Canon 400D + Sigma 10mm.

    I use Nodal Ninja 3II.

    Thanks and hope to hear soon!
  2. Re: Need help please!

    #2

    The upper rail setting is approximately 92mm. The lower rail setting is the same for most lenses so see http://www.nodalninja.com/support/camerasettings.html. You can check the settings by following the setup advice given there.

    John
  3. Re: Need help please!

    #3

    Thanks, John!
    But, i have got another question. To which direction does this plastic part (see picture) go?



    There are two options - either this small hole goes to one side or another. It makes difference on measure.

    thanks again
  4. Re: Need help please!

    #4
  5. Re: Need help please!

    #5

    Mount the NCP1 camera plate onto the camera with the screw in the hole that's in line with with the white lines, as shown in this picture from the User Guide:

    www.johnhpanos.com/ncp1.jpg

    It doesn't matter which way round the plate is attached to the upper rail. The white line will always be in line with the socket on the camera so the scale reading will be correct either way.

    John
+ Reply to Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts