NN3 MKII with Canon 10-22mm

Welcome to Nodal Ninja Forum

+ Reply to Thread
Results 1 to 8 of 8

Thread: NN3 MKII with Canon 10-22mm

Share/Bookmark
  1. NN3 MKII with Canon 10-22mm

    #1

    I couldn't find this information with the search, so I am sorry if this has been covered.
    Can anyone confirm whether or not the T apadter needs to be used with a Canon 40D and 10-22mm lens? I am about to pull the trigger on the pano head but wanted to make sure it would work for me. Thanks!
  2. Re: NN3 MKII with Canon 10-22mm

    #2
    Users Country Flag
    Join Date: Apr 2008
    Location: Hong Kong
    Posts: 2,414

    No T-adapter needed. you can find your setting here
    http://nodalninja.com/nodal_ninja_3_..._settings.html


    nick



    Fanotec
    We listen. We try harder.
  3. Re: NN3 MKII with Canon 10-22mm

    #3

    Thanks!
    Since there is some distortion with this lens at 10mm (the only focal length listed), does anyone know the setup lengths at 14mm and 22mm?
  4. Re: NN3 MKII with Canon 10-22mm

    #4

    There will probably be distortion at all focal lengths. This is not a problem as it can be corrected by the stitching software. The 10mm setting should be quite useable.

    John
  5. Re: NN3 MKII with Canon 10-22mm

    #5

    Could anyone share the rail settings of the above equipment? The nodal ninja site says at the camera settings that "page has been temporarily removed".
    Thank you!
  6. Re: NN3 MKII with Canon 10-22mm

    #6

    Quote Originally Posted by Tenn.Nole View Post
    I couldn't find this information with the search, so I am sorry if this has been covered.
    Can anyone confirm whether or not the T apadter needs to be used with a Canon 40D and 10-22mm lens? I am about to pull the trigger on the pano head but wanted to make sure it would work for me. Thanks!
    no T Adaptor required. I use lower rail of 38.



    upper rail i am using with a quick release plate thus will not be accurate for your case.

  7. Re: NN3 MKII with Canon 10-22mm

    #7

    Quote Originally Posted by Aussie Ninja
    You are showing a photograph of a lower setting of 63mm NOT 38mm
    Please refer to the Nodal Ninja 3 instructions.

    "If" a "T" Adapter was required it would be on the upper arm not the lower arm.

    Aussie Ninja

    Aussie Ninja
    oops, sorry, my bad. it is 63mm.
  8. Re: NN3 MKII with Canon 10-22mm

    #8

    I used to starting settings in the NN3 table and found it needs manual recalculation. I did some trials and found the most suitable settings are:
    Lower Rail 'A' = 43 mm
    Upper Rail 'B' = 104.5 mm

    Please confirm if these settings work with you without any parallax errors.

    http://nodalninja.com/forum/index.php?topic=319.0


    regards,
    Ayman
+ Reply to Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts