Announcement

Collapse
No announcement yet.

NN3 MKII with Canon 10-22mm

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • NN3 MKII with Canon 10-22mm

    I couldn't find this information with the search, so I am sorry if this has been covered.
    Can anyone confirm whether or not the T apadter needs to be used with a Canon 40D and 10-22mm lens? I am about to pull the trigger on the pano head but wanted to make sure it would work for me. Thanks!

  • #2
    Re: NN3 MKII with Canon 10-22mm

    No T-adapter needed. you can find your setting here
    http://nodalninja.com/nodal_ninja_3_..._settings.html


    nick
    Fanotec
    We listen. We try harder.

    Comment


    • #3
      Re: NN3 MKII with Canon 10-22mm

      Thanks!
      Since there is some distortion with this lens at 10mm (the only focal length listed), does anyone know the setup lengths at 14mm and 22mm?

      Comment


      • #4
        Re: NN3 MKII with Canon 10-22mm

        There will probably be distortion at all focal lengths. This is not a problem as it can be corrected by the stitching software. The 10mm setting should be quite useable.

        John

        Comment


        • #5
          Re: NN3 MKII with Canon 10-22mm

          Could anyone share the rail settings of the above equipment? The nodal ninja site says at the camera settings that "page has been temporarily removed".
          Thank you!

          Comment


          • #6
            Re: NN3 MKII with Canon 10-22mm

            Originally posted by Tenn.Nole View Post
            I couldn't find this information with the search, so I am sorry if this has been covered.
            Can anyone confirm whether or not the T apadter needs to be used with a Canon 40D and 10-22mm lens? I am about to pull the trigger on the pano head but wanted to make sure it would work for me. Thanks!
            no T Adaptor required. I use lower rail of 38.



            upper rail i am using with a quick release plate thus will not be accurate for your case.

            http://360.itcow.com

            Comment


            • #7
              Re: NN3 MKII with Canon 10-22mm

              Originally posted by Aussie Ninja
              You are showing a photograph of a lower setting of 63mm NOT 38mm
              Please refer to the Nodal Ninja 3 instructions.

              "If" a "T" Adapter was required it would be on the upper arm not the lower arm.

              Aussie Ninja

              Aussie Ninja
              oops, sorry, my bad. it is 63mm.
              http://360.itcow.com

              Comment


              • #8
                Re: NN3 MKII with Canon 10-22mm

                I used to starting settings in the NN3 table and found it needs manual recalculation. I did some trials and found the most suitable settings are:
                Lower Rail 'A' = 43 mm
                Upper Rail 'B' = 104.5 mm

                Please confirm if these settings work with you without any parallax errors.

                http://nodalninja.com/forum/index.php?topic=319.0


                regards,
                Ayman

                Comment

                Working...
                X