Announcement

Collapse
No announcement yet.

See the leveler bubble moves during your shots around

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • See the leveler bubble moves during your shots around

    Hi everyone,

    I've take a video to demonstrate the movement of the bubble. Once again, you only have to level the first shot!

    So do not be afraid when the bubble moves during the shots around.

    http://ge.tt/3oLxVvd/v/0 Sorry upload does not work, I will do it again.

    Hope this helps.
    Heinz
    Last edited by hindenhaag; 04-13-2013, 12:04 AM.

  • #2
    I succeeded to upload finally: You can see how the bubble moves during the shots around. But the only shots you have to level are the first one, and the Nadir2 shot, after having moved the tripod aside.

    http://ge.tt/7JVt50e/v/1

    Heinz

    Comment


    • #3
      Heinz, That's a very large file for such a short video. What is it intended to demonstrate? We all know that the bubble moves around on our own panoheads. If you get the bubble exactly in the middle for the first shot, it doesn't guarantee that the camera is exactly level for that shot, does it?

      John

      Comment


      • #4
        Heinz, I used CS6 to produce a much smaller version of your movie - 14MB instead of 230MB: http://www.johnhpanos.com/level-s.mp4

        John

        Comment


        • #5
          Hi John,

          I know that most of us know about this problem. It's a video for newbies who spend their time to level it and than having problems asking about it.

          Heinz

          Comment


          • #6
            Heinz. For a newbie, then, it's not enough to say "But the only shots you have to level are the first one and the nadir2 shot". The user is entitled to assume that the other shots can also be levelled to be on the safe side, though maybe not strictly necessary. You need to add something like "You must not re-level the head for the other shots."

            John

            Comment


            • #7
              I leveled my m2, but instead of look down at the bubble I look at from 90 degrees and 0 degrees using the sides of the bubble circle as the boundaries. When I do this and check my level as I rotate it remains within the boundaries of the bubble circle. There is a way to wash out level error, as we used to do that as calibrator in the Marines. It is meant to reduce the error, not eliminate it though.

              Comment

              Working...
              X