Nodal Ninja 5 with RD16 1 Click Off [Archive] - Nodal Ninja Forum

PDA

View Full Version : Nodal Ninja 5 with RD16 1 Click Off



ptortora
01-22-2010, 07:13 PM
I just purchased a NN5 with RD16, Quick Release and Levelor II. Upon arrival, it went together easily and finding the Nodal was straight forward as well. However, I have my click stops set at 60 degrees and although it stops every 60 degrees, my scale is 1 mark off beginning with zero and every setting thereafter (when the head is set to 0, it is showing 1 line after zero, 60 is one line after 60 and so on). I was wondering if this is normal... love the unit but having the click 1 line off from the actual markings is annoying, especially for a precision piece of gear. Any feedback will be appreciated.

hindenhaag
01-23-2010, 08:08 AM
Hallo,

I think the lower "degree plate" is misplaced. You find two tiny little hex screws, one of them at 270?. To use with the very small black imbus screw which comes with the set. Till now i did not loose this lower part. I would loossen the two screws and try to set the lower part right to 0? and re fix.

Hope this helps.

Heinz