little Planet Pano [Archive] - Nodal Ninja Forum

PDA

View Full Version : little Planet Pano



Stuman
10-19-2009, 04:56 PM
I just learned how to do these and I love the effect :001_smile: This was my first attempt. It is a 3 exposure HDR...

http://www.stumanvr.com/VRs/Planet/Planet.html

Stuman
10-20-2009, 09:58 AM
Did another last night :001_smile:

http://www.stumanvr.com/VRs/MonarchPlanet/Monarch360.html

YvesG
11-22-2009, 03:27 PM
Great job you did, I enjoyed it so much.

linkahwai
12-15-2009, 03:09 AM
Very impressing! I am beginner to pano and VR tour. Would you mind to share how did u do the animation, switching from stereographic projection to virtual tour?

YvesG
12-15-2009, 10:17 AM
Did you use krpano ?

christtramp
01-06-2010, 01:17 PM
two great examples - brilliant work.

i am new to this - i have made a couple of 360's etc - i an experimanting with software - what do you recomend ?

Christian

Bill Bailey
01-06-2010, 01:49 PM
two great examples - brilliant work.
i am new to this - i have made a couple of 360's etc - i an experimanting with software - what do you recomend ?
Christian

Hi Christian,
Welcome to the forum. I believe you'll find most folks using PTGui to stitch.
See also: http://nodalninja.com/forum/index.php?topic=62.0
Cheers
Bill

brada
01-06-2010, 08:36 PM
What is the shortest focal length lens you can use to accomplish this? I own a Sigma 10-20, would that work?

Hugh
01-08-2010, 06:28 AM
Sure, you can use a Sigma 10-20mm.
I have had successful results with this lens, especially at the 10mm end of the zoom.
See my table on:
http://www.hugha.co.uk/NodalPoint/using_the_nodal_point.htm
I used a friction panohead for the 9 directions in each plane, but 10 directions with a Nodal Ninja should also give a good answer.
I may get an opportunity to see over the weekend.

erikhoffman
02-15-2010, 07:44 AM
Did another last night :001_smile:

http://www.stumanvr.com/VRs/MonarchPlanet/Monarch360.html



How did you do this, I looked at KPRpano but didnt make any sense

Erik

hindenhaag
02-15-2010, 09:58 AM
Hi Erik,

follow the hints at the bottom of this site.

http://www.krpano.com/forum/wbb/index.php?page=Thread&threadID=2041


Heinz