PDA

View Full Version : Custom Camea Plate



fisherg
05-26-2009, 05:56 PM
I use the NN5L and Canon G9 with Canon Wide Converter WC-DC58B.
It requires using the NN Camera Plate and NN "T" adapter with an offset of 13mm.

Is it possible to have a custom made camera plate that will have the same dimensions (height for clearing the wide angle lens from the upper arm and the offset to center the lens on the center line of the upper arm) ?

This is to simplify the setup and to get a more sturdy assembly (less flex) ?

Thanks,
Guy.

nick fan
05-27-2009, 01:00 AM
I use the NN5L and Canon G9 with Canon Wide Converter WC-DC58B.
It requires using the NN Camera Plate and NN "T" adapter with an offset of 13mm.

Is it possible to have a custom made camera plate that will have the same dimensions (height for clearing the wide angle lens from the upper arm and the offset to center the lens on the center line of the upper arm) ?

This is to simplify the setup and to get a more sturdy assembly (less flex) ?

Thanks,
Guy.



our QRS2 will serve you better. It has similar thickness to a cmera mounting plate + T-adapter. It compensates off-set up to 40mm.
http://store.nodalninja.com/product_p/qrs-2.htm


Nick