PDA

View Full Version : NN3 MKII with Canon 10-22mm



Tenn.Nole
07-06-2008, 05:35 PM
I couldn't find this information with the search, so I am sorry if this has been covered.
Can anyone confirm whether or not the T apadter needs to be used with a Canon 40D and 10-22mm lens? I am about to pull the trigger on the pano head but wanted to make sure it would work for me. Thanks!

nick fan
07-06-2008, 11:31 PM
No T-adapter needed. you can find your setting here
http://nodalninja.com/nodal_ninja_3_camera_settings.html


nick

Tenn.Nole
07-08-2008, 03:45 AM
Thanks!
Since there is some distortion with this lens at 10mm (the only focal length listed), does anyone know the setup lengths at 14mm and 22mm?

John Houghton
07-08-2008, 05:49 AM
There will probably be distortion at all focal lengths. This is not a problem as it can be corrected by the stitching software. The 10mm setting should be quite useable.

John

rocketpano
09-06-2008, 11:25 AM
Could anyone share the rail settings of the above equipment? The nodal ninja site says at the camera settings that "page has been temporarily removed".
Thank you!

etegration
09-10-2008, 11:54 AM
I couldn't find this information with the search, so I am sorry if this has been covered.
Can anyone confirm whether or not the T apadter needs to be used with a Canon 40D and 10-22mm lens? I am about to pull the trigger on the pano head but wanted to make sure it would work for me. Thanks!


no T Adaptor required. I use lower rail of 38.

http://i36.tinypic.com/15p0ahf.jpg

upper rail i am using with a quick release plate thus will not be accurate for your case.

http://i34.tinypic.com/2cr52me.jpg

etegration
09-11-2008, 01:16 AM
You are showing a photograph of a lower setting of 63mm NOT 38mm
Please refer to the Nodal Ninja 3 instructions.

"If" a "T" Adapter was required it would be on the upper arm not the lower arm.

Aussie Ninja

Aussie Ninja


oops, sorry, my bad. it is 63mm. :wink:

ayman
09-22-2008, 08:43 PM
I used to starting settings in the NN3 table and found it needs manual recalculation. I did some trials and found the most suitable settings are:
Lower Rail 'A' = 43 mm
Upper Rail 'B' = 104.5 mm

Please confirm if these settings work with you without any parallax errors.

http://nodalninja.com/forum/index.php?topic=319.0


regards,
Ayman